Monoprice Cat6A Bulk Cable Guide: The Spool You Pull Through Walls Once
Researched with AI · Being re-checked by the Operator
Researched pick · Researched with AI · not a hands-on review
Retrofitting cable into a finished wall means fishing, patching drywall, and hoping. New construction removes that problem entirely — but only if the cable actually gets run before the walls close up, which means buying the spool, not a handful of pre-made patch cables.
This is Monoprice's bulk Cat6A: a 1000ft box built specifically for pulling through studs and running to every room's wall plate, not for plugging straight into a device.
Specs
- Length: 1000ft box
- Rating: Riser-rated (CMR) — safe for vertical runs between floors
- Shielding: F/UTP
- Conductor: Solid bare copper, 23AWG
- Bandwidth: 650MHz, 10G-capable
Why it's the pick
Riser-rated (CMR) matters specifically for any run that goes between floors or through a shared wall cavity — plenum-rated cable is required for HVAC air spaces, but riser is the standard baseline for most in-wall residential runs. Solid-core conductors (as opposed to stranded) are the correct choice for fixed in-wall runs; stranded cable is more flexible but not meant to sit permanently inside a wall.
Where it falls short
1000ft is a lot of cable for anything smaller than a genuine whole-home wiring project — it's not the right purchase for one or two room drops. It also requires proper termination tools (a punch-down tool, keystone jacks) to actually use; this is the raw material, not a finished cable.
Who it's for
Anyone pre-wiring a new-construction home with Cat6a drops to every room. If the need is smaller — a couple of rooms, or extending an existing setup — a shorter pre-made patch cable or a smaller spool is the more practical buy.
Sources
Guides are researched with AI and checked by the Operator. How KYRA.GG works →